HSK MEDIUM SERIES
HSK Series is usually used to bend steel, stainless steel, aliminium profile beams of various shapes in the range of medium sizes...
MPK SMALL SERIES
MPK Series is suitable for bending small range of profile and section considering lower cost and high quality...
PB MANDRELLES 100
PB Mandrelles is simple and easy to use machine to bend uncomplicated radius of different range of products.
HSK-20-40-50-60-80-100-120
General Features
HSK Series is usually used to bend steel, stainless steel, aliminium profile beams of various shapes in the range of medium sizes. On this model the adjustment of upper roll is done by hydraulic cylinder and it is offered in different sizes.
HSK 20-40 – 50 – 60 STANDARD EQUIPMENT
- Steel welded construction frame
- HPK 41 2 rolls, HPK 50/60 3 rolls are motor driven
- Hardened shafts from special steel material
- Top roll hydraulic moveable up-down
- Horizontal and vertical working position
- Standard rolls
- Guide rolls
- Brake motor equipped for the precision bending
- Mobile control panel
HSK 80 – 100 – 120 STANDARD EQUIPMENTS
- Steel welded construction frame
- Hardened shafts from special steel material
- Top roll hydraulic moveable up-down
- Horizontal and vertical working position
- Standard rolls
- Guide rolls
- Brake motor equipped for the precision bending
- Mobile control panel
Models
MPK-20-40-50
General Features
MPK Series is suitable for bending small range of profile and section, considering low cost and high quality.
On this model the adjustment of upper roll is done manually and it is offered in 3 different sizes.
MPK 20 STANDARD EQUIPMENTS
- 2 driving rolls
- Pipe bending capacity up to Ø25mm
- Angle iron bending capacity up to 20x20mm
- Manual Hand Lever adjustment of Top Bending roll
- Combination horizontal-vertical working position,
MPK 40 – 50 STANDARD EQUIPMENTS
- Steel frame
- Two bottom rolls are powered
- Direct drive power system with gears
- Top roll is idle ( free turning )
- Hardened rolls
- Rolls shafts are special steel material hardened and ground
- Double speed motor
- Standard rolls
- Adjustable guide rolls
- Horizontal and vertical working position,
Models
PB MANDRELLES 100
General Features
PB is a mandrelless pipe bendıng machine that is simple and easy to use. This machine can be used to bend uncomplicated radius of different range of pipes.
- CK 45 Monoblok Frame
- Reducer Driven
- All Shafts and Necessary party are hardened and grinded
- Digital read out
- Counter for back support
- Invertor and speed adjustment
